6 Aug
2014
6 Aug
'14
1:44 a.m.
On 4 August 2014 at 18:52, Ivan K <ivan_521521(a)yahoo.com> wrote:
I have successfully recorded from my
USBDualTubePre microphone preamp using the S/PDIF
into my M-Audio 2496. I used mhWaveEdit.
The issue was that qjackctl was displaying the
Readable Clients/Output Ports and
Writable Clients/Input Ports of my _motherboard_
audio, not my M-Audio 2496.
A recent off list reply coached me to set the
correct device in Qjackctl with "Setup | Interface | >".
Early on, Len Ovens informed me that the S/PDIF
inputs of the ice1712 are 9 and 10.
And of course, using envy24control to set "Master clock"
to s/pdif rather than a sample rate was required as well.
And so, thank you to all who responded!
Thanks for the discussion and your conclusions. I'm about to try
to transfer the content of an audio DAT tape using a Panasonic
DAT deck via the S/PDIF i/o on my Delta 1010 audio interface.
You all may have just saved me some headaches. FWIW, I'll be
attempting this using Ardour, which plays quite nicely with
JACK[12], and plays quite nicely on my system in general. But,
S/PDIF is new to me.
Cheerio....
--
Kevin