9 Sep
2003
9 Sep
'03
1:30 p.m.
It looks to me like a good place to put this info is in the "user notes"
attached to the ALSA sound card matrix:
visit http://www.alsa-project.org/alsa-doc/
find matrix line for your card, click "details"
click "user contributed notes"
click "ADD".
Sure I could do it myself but it's not my info, I don't even have this kind of
sound card.
There is also a WIKI for ALSA soundcard HOWTOs at
http://alsa.opensrc.org/index.php?page=AlsaOpensrcOrg but it looks to me like
it is less active recently.
On Tuesday 09 September 2003 11:22 am, Robert Epprecht wrote:
Robert Epprecht <epprecht(a)solnet.ch> writes:
I'm having a hard time bringing my new RME
pci interface and Multiface
to run... and would appreciate some help ;-)
And I have got a *lot* of help on the list and by PM.
I'd like to say thank you very much to everybody who helped me!
The problem was my firmware version. I had version 10 and have upgraded
to version 11. Now everything I have tested so far works like expected!
Some important steps that I had missed on the path of setting up a
RME Hammerfall DSP card (in my case a PCI interface and a multiface)
on a Linux box using ALSA:
* You can determine the firmware version by doing 'lspci -vv'
* Firmware version 10 (0a) did not work for me,
version 11 (0b) seems to run fine as far as I can tell by now.
(This version is the current version on the RME webside).
* If you use the snd-hdsp module you have to call hdsploader from
alsa-tools after loading the module.
* Things like un-muting, setting channel levels and channel routing is done
in hdspmixer from alsa-tools.
* Settings like Clock sync, sample rate and type of SPDIF in/out are set
by the program called 'hdspconf'.
Robert Epprecht