30 Jan
2020
30 Jan
'20
1:38 p.m.
Adding to that:
If in Windows, I plug in a mic into channel 1 and turn up the input
gain, the input LEDs respond as they should to incoming sound. I can
also in the Focusrite Control sodtware, map the input directly to the
monitor so that I I can hear it in the headphones. If I then reboot the
laptop, the LED and routing continue to function until the machine loads
the Grub system boot page, whereupon the LED stops functioning and the
monitoring of the mic also stops. The mic channel remains unresponsive
when Linux is booted. This is a bit worrying as I had read for earlier
generations that the control routing set in Windows is remembered by the
Scarlett once in Linux (and presumably after switching the box on and off).
The F6 button in alsamixer shows "Scarlett 18i20 USB", however once
selected, for capture/input, it says something to the effect of: this
device has no input/capture controller. For reproduction/playback it
lists only S/PDIF but with no fade controler.
Hope someone can help!
Iain
Em 30/01/2020 06:24, Iain Mott escreveu:
Dear Linux audio people,
I have a Scarlett 18i20 3rd Gen interface which I'm trying to use on a
recent Samsung laptop with Ubuntu 19.04.
The 3rd gen devices are apparently shipped in non-functional "MSD"
mode, so I registered and activated the device using Windows 10
following the instructions on the Focusrite website. Tested it there
with Ableton Live Lite (provided via registration of the device) and
also Ardour. It works fine. To get it to work on Ardour it was
necessary to use the ASIO driver in the Ardour audio configuration. I
had removed ASIO4ALL before installing the Focusrite/Scarlett software
as suggested, so perhaps this driver came with Focusrite install.
Now with the device apparently configured and the routing done in
Windows using the Focusrite Control software (i thinks that's the
name, I had selected output channels 1 and 2 to connect with the
monitors/headphone jack), I returned to Linux. The Scarlett device is
detected by lsusb, qjackctl and pavucontrol. Jack runs with no errors
when the Scarlett is selected as the i/o device and all the correct
channels appear in the Connect window. No sound however is heard
through the phone jack, nor if i plug the phones directly in to the
output jacks at the back. I tested using VLC configured for Jack
output and also with pd -jack.
With jack turned off and with VLC audio out set to pulsaudio, I set
the Scarlett 18i20 as the preferred device in pavucontrol. With VLC
playing the output VU meter for the Scarlett is active in pavucontrol
but there is still no sound coming out of the device itself.
Has anyone managed to get a 3rd generation Scarlett to work on Linux?
Can anyone suggest please what I can do?
Thanks!
Iain
PS. i did see an unresolved thread on this list last year about a 3rd
gen Scarlett. I'll send a message to the author to see if the problem
was fixed.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user(a)lists.linuxaudio.org
https://lists.linuxaudio.org/listinfo/linux-audio-user