12 Sep
2005
12 Sep
'05
6 a.m.
Hi Peder,
--- Peder Hedlund <peder(a)musikhuset.org> wrote:
Bug (?) :
I have a 24 bit stereo track in Ardour connected to
Jamin and returned
to another stero track. When the mastering is done I
export the mastered
track to 16 bit wav. Everything works, but after
Ardour has exported 100%
(and before closing the export screen) it's dead for
15-45 secs.
During this, 'top' shows 85-95% CPU usage for Jamin.
If I close Jamin before exporting, Ardour responds
directly.
I see this too. Until someone fixes it, just let it
run it's course.
Question:
I have an Ardour session with 17 tracks that have
EQ, compression and
the occasional effect pre-fader, a phaser on a
pre-fader send bus and a
stereo reverb pre-fader on the master bus.
If I route the master bus to Jamin and back in on a
stereo track
the Jamin output sounds fine, but the stereo track
ends up with none of
the effects.
Is it impossible to do a multitrack mastering with
the effects intact
or am I doing something wrong?
Ardour; Options, Miscelaneous, Run Plugins While
Recording.
There was a point when I thought this was a bug. I
installed Timemachine and started recording mixes into
it. dah!
ron
HW/SW specs: AMD AthlonXP 1200+, 512MB RAM, SB
Live!, kernel 2.6.12
rlimits, jack in RT mode. Ardour CVS from Aug 31 and
Jamin CVS from
mid/end July.
Regards,
Peder
______________________________________________________
Yahoo! for Good
Watch the Hurricane Katrina Shelter From The Storm concert
http://advision.webevents.yahoo.com/shelter