14 Nov
2006
14 Nov
'06
11:34 a.m.
Giuseppe Zompatori wrote:
Hard to describe the mess that's going on with this (not saying it's
your fault of course), master volume control seems to not be working
but for lowering line-in monitoring levels, changing line-in
monitoring does nothing.
A newer driver version might fix things.
Which codec are you using? (see /proc/asound/cards)
Regards,
Clemens
cmd: 0xff failed at 0x300 (status = 0xff, data =
0xff)
when trying to access the port.
# cat /proc/ioports | grep MPU
0330-0331 : MPU401 UART <- that's corret I set this to 330 int the BIOS setup
cat /proc/interrupts | grep MPU
11: 1 IO-APIC-edge MPU401 UART <- that's also correct IRQ set to 11
in the BIOS
Then it's probably not a problem with the port address.
In what previous kernel version did this work?
Do you know which ALSA version this was?
as I also have issues with the HW mixer... things are
swapped around,
and there is no "ac97_quirk" module parameter for remapping things
that works.
Which mixer controls are routed to which hardware outputs?