29 Nov
2005
29 Nov
'05
11:41 a.m.
On 11/29/05, Kai Vehmanen <kvehmanen(a)eca.cx> wrote:
Thanks Kai.
By the way, I'm just trying to use ecasound as a command line ladspa
host. Is there a simpler way to do this, or will I just have to write
some scripts? Is it possible to use the interactive mode to add a
ladspa plugin on the fly?
One last comment: I was surprised that ecasound exits when the jack
mode is "recv" and I stop the transport. I suppose that is the
intended behavior?
--
paul
Hi Paul,
On Mon, 28 Nov 2005, Paul Coccoli wrote:
Oops; my bad. 2.4.2 is the latest in Planet CCRMA. I was wondering
why the man page had so little to say about alsaseq.
I get that plate reverb error no matter what options I use. Is that
something in my system configuration?
ecasound is way too complicated for me. All I
want to do is open jack
stereo ins and outs, load the LADSPA amp_stereo plugin, and control
that plugin's gain parameter via alsa midi.
[...]
The -Md:alsaseq parameter is apparently ignored,
and I get some error
about a plate reverb?!
the problem is that ALSA sequencer support was added to ecasound-2.4.3 and
you are using ecasound-2.4.2. So you'll need to upgrade. Otherwise your
setup looks ok.
[paul@localhost paul]$ ecasound -i jack -o jack
-G:jack,ecasound,notransport -el:amp_stereo,1 -Md:alsaseq
-km:1,0,1,1,1
[...]
ERROR: Connecting chainsetup failed: "Unable
to open MIDI-device: rawmidi."
This is perhaps not the best possible error message for the situation... will
be fixed in a later release.
--
links, my public keys, etc at http://eca.cx/kv