2 Feb
2005
2 Feb
'05
4:49 a.m.
On Wed, Feb 02, 2005 at 04:12:39PM +1000, vector wrote:
Hi
newbie
Just grasping the ins and outs of jack
basic sound blaster card
tone present on line in
qjackctl shows capture_1, .. _2.
I can remove the route of capture_1 etc to things like ardour by
disconnecting it in qjackctl as expected.
however I cant stop the line input from being "mirrored" on the cards
output.
gnomes volume control ..line slider allows me to adjust the volume.
(like a pre fader) but no matter what i disconnect in jack the tone on
line input also comes out of the cards output.
I'm not sure how the architecture of all this is done (I'm still
learning) but I found that I have to mute the line to make it silent. I
did that in alsamixer. Just go to the "line" and press "m".
regards,
- Bengan --------------------------------------------------------------
- KTHNOC/SUNET/NORDUnet | http://www.sunet.se/~bengan | +46 8 7906586 -