Re: [linux-audio-user] still have bad sound

On Fri, 2004-02-13 at 06:01, Dave Phillips wrote: and to you too... Since you're getting into this, have you checked the MIN_GNT and MAX_LAT values in the PCI config space of your sound card? Setting the PCI Latency timer to a higher value only keeps your card on the bus longer when it finally gets the bus. It doesn't do anything to help it gain access to the bus sooner. It's probably that some *other* PCI device is holding the bus and starving you out. Since it appears to be related to your mouse and hard drives, it would seem to be your South Bridge since that's what likely controls both of them. Anyway you can look at a few options: 1) Get a good IRQ. I have an older Dell P3 500 that has this same 'mouse causes noise on AP2496 under Windows ME' sort of problem when the sound card is on IRQ 3,4,5,6 or 7. (Assuming traditional IRQs and not APIC/IO-APIC IRQs.) By moving the card to IRQ9 the problem goes away. (I know Clemens said the other day that this doesn't matter, but on my systems it has and continues to matter. I acknowledge the physics in my universe are somewhat cartoonish at times...) ;-) 2) If it's not an IRQ issue, then maybe you need to get the *other* devices *off* the PCI bus faster. To do this you would *lower* their latency timer values. However, you should really look at the MIN_GNT and MAX_LAT values in all of their PCI config spaces. Lower their latency timers (or try it) but don't lower them further than their MAX_LAT values. (IMPORTANT FYI - MIN_GNT and MAX_LAT are specified in terms of 1/4 microsecond units, not clock cycles while Latency Timer is specified in terms of PCI clocks. You need to do the conversions! Ask questions if you need to.) IMPORTANT FYI #2: Messing with any of these values on your disk drives may lead to corruption. Just some idea. Good luck, Mark