30 Jun
2010
30 Jun
'10
1:53 a.m.
On Tue, Jun 29, 2010 at 4:03 PM, J. <jonathangoodman(a)bezeqint.net> wrote:
(1) Why when the jack control setup says sample rate
44.1 the status says
48. All I need at this point is 44.1 who do I change it to that.
you can't. you are using consumer audio hardware that only runs at
48kHz. it "works on windows" because the windows driver lies about it,
and does resampling. you could achieve a similar effect by making jack
use a device called "plughw:XXXX" rather than "hw:XXXX" as you are
probably doing now. the CPU load will go up and the resampling quality
is poor. JACK is picking the sample rate that is available and closest
to what you asked for rather than failing. People didn't like it much
when it would just fail.
(2) There are times when I need to stop jack. When I
do the disk player
clicks and played 1/step flat. and my finale notation on wine doesn't access
timidity++ (as it does before I start jack). What is the problem?
these apps are the problem. your only workaround is to quit them and
restart them after you restart JACK.
(3) I have had to shut off timidity++ on the command
line to get it to start
as a Rose garden service. I have forgotten how to do this and how to start
it for Rose garden. sometimes when I start timidity++ as a Rose garden
service every thing crashes What to do.
no idea about these issues.