2 Oct
2009
2 Oct
'09
7:12 p.m.
Fons,
Thanks a lot for your informative answer, but I'm still slightly confused.
:(
I've set my a button on my controller to midi CC 98 and then set it to
toggle between a value of 00 and 2, so it should toggle the second stop of
the manual on and off?
I really feel I have missed something vitally important here.....
The README says that the value used is a bit 6 set... Is it even possible to
get standard hardware midi controllers to send that kind of info?
Also, thanks a million for writing the software!
Andrew.
On Fri, Oct 2, 2009 at 11:37 AM, Fons Adriaensen <fons(a)kokkinizita.net>wrote;wrote:
On Fri, Oct 02, 2009 at 10:06:08AM +0100, Andrew C
wrote:
I've read and read and re-read the README of
the latest release of aeolus
that includes midi control of the stops and I still don't understand how
to
specifically program the 'bytes' on midi
CC 98 or so..
Is this like sending raw midi sysex data or what?
No, it's just using controller 98. The data in a control message
is a single byte, that value is exlained in the readme.
You typically need two controller messages: one that
selects a groupt of stops (corresponding to the layout
in the GUI) and the mode: on, off, toggle, and the
second message selects a stop in the group. You don't
need to repeat the first if it's identical to the
previous one.
--
FA
Io lo dico sempre: l'Italia è troppo stretta e lunga.
_______________________________________________
Linux-audio-user mailing list
Linux-audio-user(a)lists.linuxaudio.org
http://lists.linuxaudio.org/mailman/listinfo/linux-audio-user