20 Jul
2003
20 Jul
'03
9:51 p.m.
I'm using an RME Digi96/8 PAD and I'm trying to configure ALSA so that when JACK
loads it will provide transports to both the stereo device and the ADAT device on the
card. I think the proper way to do this is by creating a virtual multi device but I
can't find much info other than just an example on how to set it up. The multi device
is easy enough to figure out, but I'm not quite sure how to set up the interleaved PCM
stream correctly, the example given on the ALSA website is for a 4 channel setup and I
need to set one up for 10 channels.
Here's my current .asoundrc:
pcm.rme_stereo {
type hw
card 0
device 0
}
ctl.rem_stereo {
type hw
card 0
device 0
}
pcm.rme_adat {
type hw
card 0
device 1
}
ctl.rme_adat {
type hw
card 0
device 1
}
pcm.multi {
type multi;
slaves.a.pcm rme_stereo;
slaves.a.channels 2;
slaves.b.pcm rme_adat;
slaves.b.channels 8;
bindings.0.slave a;
bindings.0.channel 0;
bindings.1.slave a;
bindings.1.channel 1;
bindings.2.slave b;
bindings.2.channel 0;
bindings.3.slave b;
bindings.3.channel 1;
bindings.4.slave b;
bindings.4.channel 2;
bindings.5.slave b;
bindings.5.channel 3;
bindings.6.slave b;
bindings.6.channel 4;
bindings.7.slave b;
bindings.7.channel 5;
bindings.8.slave b;
bindings.8.channel 6;
bindings.9.slave b;
bindings.9.channel 7;
}
ctl.multi {
type hw;
card 0;
}
Also, if there is a better/easier way to do this please tell me.
-Reuben