Re: [linux-audio-user] RME Hammerfall DSP Multiface firmware loading problem

I powered down and unplugged everything. After reconnecting everythingand turning the (desktop) computer on, the "Host Error" light on themultiface went out and the kernel log contained: Hammerfall-DSP: wait for FIFO status <= 0 failed after 30 iterationsHammerfall-DSP: loading firmwareHammerfall-DSP: finished firmware loading Now, when I run hdspconf and select any option (e.g. change samplingrate), I get an error for each option selected. For example, if Ichange the sampling rate to 44.1 kHz the radio button selection"jumps" back to 48 kHz. The stdout of hdspconf looks like: HDSPConf 1.4 - Copyright (C) 2003 Thomas Charbonnel &lt;thomas(a)undata.org&gt;This program comes WITH ABSOLUTELY NO WARRANTYHDSPConf is free software, see the file copying for details Looking for HDSP cards :Card 0 : VIA 82C686A/B rev50 with ICE1232 at 0xa800, irq 9Card 1 : RME Hammerfall DSP + Multiface at 0xdd000000, irq 9Multiface found !1 Hammerfall DSP card found.Error accessing ctl interface on card hw:1Error accessing ctl interface on card hw:1Error accessing ctl interface on card hw:1 The last message is repeated every time I attempt to change a setting,and it doesn't show up at all until I try to change a setting. If Iclose hdspconf and run amixer -c 1 cset numid=11 2(syntax from http://www.linuxjournal.com/article/7024) the correct (44.1 kHz) setting shows up when I reopen hdspconf.Changing the rate back to 48 kHz in hdspconf results in the sameerror, except the selection now remains fixed at 44.1 kHz. Any thoughts on why this is happening? Is the version of HDSPConf too old? - Matt On 12/16/05, Paul Davis &lt;paul(a)linuxaudiosystems.com&gt; wrote:> try power-cycling *everything*. the computer, (including unplugging the> power cord (and battery if its a laptop), and the multiface box.>> i've run into this condition once or twice, and the only solution i have> found is a complete power cycle of everything.>>> --p