10 May
2011
10 May
'11
9:19 p.m.
On Tue, May 10, 2011 at 08:07:48AM -0700, menno wrote:
i'd like to get information on Aeolus from Fons
Adriaensen, the link to his page seems to be dead.
I'd like to know about how to access and use the stops with midi.
Is there a good doc somewhere?
The website is available on <http://kokkinizita.linuxaudio.org>.
The README in the source distribution explains how to control
the stops using MIDI. I copy the relevant section below.
6. Midi control of stop buttons
-------------------------------
The protocol uses one controller number. The default is #98, but you
can change this in global.h. The message is accepted only on channels
enabled for control in the midi matrix.
The value is interpreted as follows:
v = 01mm0ggg
This type of messages (bit 6 set) selects a group, and either
resets all stops in that group or sets the mode for the second
form below.
mm = mode. This can be:
00 disabled, also resets all elements in the group.
01 set off
10 set on
11 toggle
ggg = group, one of the button groups as defined in the instrument
definition. In the GUI groups start at the top, the first one (for
division III) being group #0.
The values of mm and ggg are stored and need not be repeated unless
they change.
v = 000bbbbb
According to the current state of mode, this command switches a
stop on or off, or toggles its state, or does nothing at all.
bbbbb = button index within the group.
Buttons are numbered left to right, top to bottom within each
group. The first one is #0.
Ciao,
--
FA