6 Feb
2004
6 Feb
'04
10:22 a.m.
Hi Thomas,
hdsploader cand find my card for some reason:
hdsploader:
[root@localhost robcanning]# hdsploader
hdsploader - firmware loader for RME Hammerfall DSP cards
Looking for HDSP + Multiface or Digiface cards :
Card 0 : Intel ICH5 at 0xfebfb800, irq 5
yet lspci -vv reveals:
03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev
32)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 5
Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
thanks,
rob
6 Feb
6 Feb
3:07 p.m.
hdsploader cand find my card for some reason:
hdsploader:
[root@localhost robcanning]# hdsploader
hdsploader - firmware loader for RME Hammerfall DSP cards
Looking for HDSP + Multiface or Digiface cards :
Card 0 : Intel ICH5 at 0xfebfb800, irq 5
What do you see if you do a "cat /proc/asound/cards"? Do you see both
cards or just your motherboard sound chip?
yet lspci -vv reveals:
03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev
32)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 5
Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
That means the card is recognized by the pci subsystem, it does not tell
you anything about alsa (ie: the card could be there with no driver
loaded).
-- Fernando
3:31 p.m.
rob canning wrote :
Hi Thomas,
hdsploader cand find my card for some reason:
hdsploader:
[root@localhost robcanning]# hdsploader
hdsploader - firmware loader for RME Hammerfall DSP cards
Looking for HDSP + Multiface or Digiface cards :
Card 0 : Intel ICH5 at 0xfebfb800, irq 5
yet lspci -vv reveals:
03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev
32)
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+
SERR+ FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Latency: 64
Interrupt: pin A routed to IRQ 5
Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K]
thanks,
rob
Hi Rob,
You should first check if the module was properly loaded (/sbin/lsmod),
then check you modules.conf file. In one of your previous mails one hdsp
line looked dodgy :
alias snd-card-0ntitlntitled 1ntitled 1ed 1 snd-hdsp
Maybe you should run alsaconf again to start from a clean basis.
Hope this helps,
Thomas
7629
days inactive
7629
days old
linux-audio-user@lists.linuxaudio.org
2 comments
3 participants
participants (3)
-
Fernando Pablo Lopez-Lezcano -
rob canning -
Thomas Charbonnel