hi all, i've got a problem with my brand new hdsp multiface / cardbus ... i got everything working so far ... modules are installed and can upload the firmware ... i can even use the hdspmixer to mix the incoming sounds to the outputs ... but i didn't manage to play any sound from the computer ... i can start jack / pd / spiralmodular, but all i hear is a distorted sound, that sounds a bit similar to what i expect the signal to sound ... the pitch of the distortion changes when i change the rate of the sample clock source ... any idea what could cause this behaviour ? btw, i can't start jack when i set the sample clock source to values greater than 62khz ... the strangest thing ... when starting the audio application, the output signal that is routed from the input channels has these distortions, too, until i stop the application... i've been trying alsa 0.9.8 and 1.0.0_rc2 and i downgraded the firmware from rev. 11 to 10 ... any hints? Tim mailto:TimBlechmann@gmx.de ICQ: 96771783 http://www.nyds-exp-discogs.tk -- The only people for me are the mad ones, the ones who are mad to live, mad to talk, mad to be saved, desirous of everything at the same time, the ones who never yawn or say a commonplace thing, but burn, burn, burn, like fabulous yellow roman candles exploding like spiders across the stars and in the middle you see the blue centerlight pop and everybody goes "Awww!" Jack Kerouac -- Tim mailto:TimBlechmann@gmx.de ICQ: 96771783 http://www.nyds-exp-discogs.tk -- The only people for me are the mad ones, the ones who are mad to live, mad to talk, mad to be saved, desirous of everything at the same time, the ones who never yawn or say a commonplace thing, but burn, burn, burn, like fabulous yellow roman candles exploding like spiders across the stars and in the middle you see the blue centerlight pop and everybody goes "Awww!" Jack Kerouac