I have a midiman uno usb device. I am not sure if I am using it correctly or not. I compiled and installed ezusb2131 and usb-midi (not realizing usb-midi is in the kernel) I load the ezusb2131 with: modprobe ezusb2131 vendor_id=0x763 product_id=0x110 I then cat the firmware into the device. I then load usb-midi. This is how I do it manually when hotplug does not work correctly. dmesg list that I have a /dev/midi02 now. My first question is if I am setting up the above correctly? My second question is how do I use it besides with muse, csound, and pd? Muse does not detect the device. I have to add a new raw midi device in the midi configuration of muse. That is ok but should it be detected. I can't get it to work with other sequencers at all because most of them don't allow you to add raw midi devices. Now csounds and pd will listen to a raw midi device. The way I have been using it is through muse. Then I set up any other synth in muse. Thanks, Jeremiah