Hi, I installed Electronic Instruments 2 (wich is available as trail version) using wine. After starting it with fst the gui shows up. But after having asked me for the standart autosave dir it crashes. I'm using fst-1.8 and wine 0.9.17~winehq0~ubuntu6.01-1 I Here is my log: sonium@raumstation:~/Desktop/fst-1.8$ ./fst ~/.wine/drive_c/Program\ Files/Steinberg/VstPlugins/VSTPlugins/Photone\ EI2XT.dll yo... lets see... err:midi:MIDI_AlsaToWindowsDeviceType Cannot determine the type (alsa type is 100000) of this midi device. Assuming FM Synth err:midi:MIDI_AlsaToWindowsDeviceType Cannot determine the type (alsa type is 100000) of this midi device. Assuming FM Synth fixme:shell:BrsFolder_OnCreate flags 40 not implemented The program 'fst' received an X Window System error. This probably reflects a bug in the program. The error was 'RenderBadPicture (invalid Picture parameter)'. (Details: serial 9890 error_code 180 request_code 154 minor_code 7) (Note to programmers: normally, X errors are reported asynchronously; that is, you will receive the error a while after causing it. To debug your program, run it with the --sync command line option to change this behavior. You can then get a meaningful backtrace from your debugger if you break on the gdk_x_error() function.) sonium@raumstation:~/Desktop/fst-1.8$ ./fst ~/.wine/drive_c/Program\ Files/Steinberg/VstPlugins/VSTPlugins/Photone\ EI2XT.dll yo... lets see... err:midi:MIDI_AlsaToWindowsDeviceType Cannot determine the type (alsa type is 100000) of this midi device. Assuming FM Synth err:midi:MIDI_AlsaToWindowsDeviceType Cannot determine the type (alsa type is 100000) of this midi device. Assuming FM Synth fixme:shell:BrsFolder_OnCreate flags 40 not implemented The program 'fst' received an X Window System error. This probably reflects a bug in the program. The error was 'RenderBadPicture (invalid Picture parameter)'. (Details: serial 8623 error_code 180 request_code 154 minor_code 7) (Note to programmers: normally, X errors are reported asynchronously; that is, you will receive the error a while after causing it. To debug your program, run it with the --sync command line option to change this behavior. You can then get a meaningful backtrace from your debugger if you break on the gdk_x_error() function.)