26 Sep
2004
26 Sep
'04
6:24 p.m.
This may be semi-OT for this list but it does relate somewhat in
regards to burning CDs and eventually using the 2.6 kernels for low
latency audio, etc.
My production distro is a Planet CCRMA RH 9 installation. I also
have an installation of FC2 that I use for graphics and will
eventually be migrating to. For me, using FC2 and the 2.6 kernels
is edgy enough -- I don't have enough knowledge and experience to be
much use as a beta tester.
With those caveats in mind, is there a particular 2.6 kernel that
would be better than either 1) the kernel that was shipped with my
FC2 disks, or 2) the most recently released kernel (2.6.8-1.521)?
Where can I find more info about the various kernels and other
updates as they are released? Does anyone have any advice as to an
FC2 update strategy other than running `# yum update` every week
or so?
Thanks,
Barton
26 Sep
26 Sep
9:23 p.m.
On Sun, 2004-09-26 at 12:50, Barton Bosch wrote:
This may be semi-OT for this list but it does relate
somewhat in
regards to burning CDs and eventually using the 2.6 kernels for low
latency audio, etc.
My production distro is a Planet CCRMA RH 9 installation. I also
have an installation of FC2 that I use for graphics and will
eventually be migrating to. For me, using FC2 and the 2.6 kernels
is edgy enough -- I don't have enough knowledge and experience to be
much use as a beta tester.
With those caveats in mind, is there a particular 2.6 kernel that
would be better than either 1) the kernel that was shipped with my
FC2 disks, or 2) the most recently released kernel (2.6.8-1.521)?
I have released a couple of "experimental" 2.6.8+ kernels that include
the voluntary preemption patches by Ingo Molnar. They are getting better
all the time. You could try them in your FC2 box by following the
instructions here (if you have already installed Planet CCRMA in your
FC2 box, of course):
http://ccrma-mail.stanford.edu/pipermail/planetccrma/2004-August/005879.html
Where can I find more info about the various kernels
and other
updates as they are released?
Kernels specific for Planet CCRMA are announced in its mailing list. I
guess the place for generic announcements would be the linux kernel
mailing list.
Does anyone have any advice as to an
FC2 update strategy other than running `# yum update` every week
or so?
For Planet CCRMA that would be apt-get update; apt-get dist-upgrade. I
have yum support in my list of things to do but have not had time to
implement it yet.
-- Fernnado
27 Sep
27 Sep
2:52 p.m.
On Sunday 26 September 2004 04:06 pm, Fernando Pablo Lopez-Lezcano wrote:
On Sun, 2004-09-26 at 12:50, Barton Bosch wrote:
Are the .src rpms for these builds available in the Planet's site? I looked
for them but could not see. I want to recompile and try this kernel on
another rpm based distro...
R~
This may be semi-OT for this list but it does
relate somewhat in
regards to burning CDs and eventually using the 2.6 kernels for low
latency audio, etc.
My production distro is a Planet CCRMA RH 9 installation. I also
have an installation of FC2 that I use for graphics and will
eventually be migrating to. For me, using FC2 and the 2.6 kernels
is edgy enough -- I don't have enough knowledge and experience to be
much use as a beta tester.
With those caveats in mind, is there a particular 2.6 kernel that
would be better than either 1) the kernel that was shipped with my
FC2 disks, or 2) the most recently released kernel (2.6.8-1.521)?
I have released a couple of "experimental" 2.6.8+ kernels that include
the voluntary preemption patches by Ingo Molnar. They are getting better
all the time. You could try them in your FC2 box by following the
instructions here (if you have already installed Planet CCRMA in your
FC2 box, of course):
http://ccrma-mail.stanford.edu/pipermail/planetccrma/2004-August/005879.htm
l
--
The Road of Life is paved with Squirrels that couldn't make a decision!
Where can I find more info about the various
kernels and other
updates as they are released?
Kernels specific for Planet CCRMA are announced in its mailing list. I
guess the place for generic announcements would be the linux kernel
mailing list.
Does anyone have any advice as to an
FC2 update strategy other than running `# yum update` every week
or so?
For Planet CCRMA that would be apt-get update; apt-get dist-upgrade. I
have yum support in my list of things to do but have not had time to
implement it yet.
-- Fernnado
5:49 p.m.
On Mon, 2004-09-27 at 09:36, Russell Hanaghan wrote:
On Sunday 26 September 2004 04:06 pm, Fernando Pablo
Lopez-Lezcano wrote:
Yes, they are available, look at:
http://ccrma.stanford.edu/planetccrma/mirror/all/linux/SRPMS/
-- Fernando
On Sun, 2004-09-26 at 12:50, Barton Bosch wrote:
Are the .src rpms for these builds available in the Planet's site? I looked
for them but could not see. I want to recompile and try this kernel on
another rpm based distro... This may be semi-OT for this list but it does
relate somewhat in
regards to burning CDs and eventually using the 2.6 kernels for low
latency audio, etc.
My production distro is a Planet CCRMA RH 9 installation. I also
have an installation of FC2 that I use for graphics and will
eventually be migrating to. For me, using FC2 and the 2.6 kernels
is edgy enough -- I don't have enough knowledge and experience to be
much use as a beta tester.
With those caveats in mind, is there a particular 2.6 kernel that
would be better than either 1) the kernel that was shipped with my
FC2 disks, or 2) the most recently released kernel (2.6.8-1.521)?
I have released a couple of "experimental" 2.6.8+ kernels that include
the voluntary preemption patches by Ingo Molnar. They are getting better
all the time. You could try them in your FC2 box by following the
instructions here (if you have already installed Planet CCRMA in your
FC2 box, of course):
6:54 p.m.
On Monday 27 September 2004 12:32 pm, Fernando Pablo Lopez-Lezcano wrote:
On Mon, 2004-09-27 at 09:36, Russell Hanaghan wrote:
Thanks Fernando. I'm going to attempt repackaging for Yoper Distro.
R~
--
The Road of Life is paved with Squirrels that couldn't make a decision!
On Sunday 26 September 2004 04:06 pm, Fernando
Pablo Lopez-Lezcano wrote:
Yes, they are available, look at:
http://ccrma.stanford.edu/planetccrma/mirror/all/linux/SRPMS/
-- Fernando On Sun, 2004-09-26 at 12:50, Barton Bosch wrote:
Are the .src rpms for these builds available in the Planet's site? I
looked for them but could not see. I want to recompile and try this
kernel on another rpm based distro... This may be semi-OT for this list but it does
relate somewhat in
regards to burning CDs and eventually using the 2.6 kernels for low
latency audio, etc.
My production distro is a Planet CCRMA RH 9 installation. I also
have an installation of FC2 that I use for graphics and will
eventually be migrating to. For me, using FC2 and the 2.6 kernels
is edgy enough -- I don't have enough knowledge and experience to be
much use as a beta tester.
With those caveats in mind, is there a particular 2.6 kernel that
would be better than either 1) the kernel that was shipped with my
FC2 disks, or 2) the most recently released kernel (2.6.8-1.521)?
I have released a couple of "experimental" 2.6.8+ kernels that include
the voluntary preemption patches by Ingo Molnar. They are getting
better all the time. You could try them in your FC2 box by following
the instructions here (if you have already installed Planet CCRMA in
your FC2 box, of course):
7158
days inactive
7159
days old
linux-audio-user@lists.linuxaudio.org
4 comments
3 participants
participants (3)
-
Barton Bosch -
Fernando Pablo Lopez-Lezcano -
Russell Hanaghan