Dne pondělí 29 říjen 2007 15:03 Kevin Cosgrove napsal(a): > A bit over a month ago my BCF2000 was working just fine. I > didn't have to do much special with it, just plug it in via USB, > turn it on, and put it into "Logic Control" mode. Then it would > show up in /proc/asound as card3. But, now it doesn't show up in > /proc/asound. No messages appear in /var/log/messages. Where > should I start to troubleshoot this?

Check the usb cable. Or you can reset it to the initial state, which AFAIK has usb connection turned on by default. /var/log/messages or dmesg should show something like usb 4-1: new low speed USB device using uhci_hcd and address 2 at least