Dear List, testing ardour and jack to do a concert recording tonight, and get jack disconnects: CONSOLE OUTPUT: Loading session /fw3_fat/foobar using snapshot foobar ... Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (256 peaks instead of 288) (Success) at start_byte = 114432 _length = 3735552 expected maxpeaks = 288 npeaks was 288 Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (256 peaks instead of 288) (Resource temporarily unavailable) at start_byte = 157440 _length = 5111808 expected maxpeaks = 288 npeaks was 288 Source[Audio 1-4%R.wav]: cannot read peak data from peakfile (896 peaks instead of 368) (Resource temporarily unavailable) at start_byte = 253056 _length = 8192000 expected maxpeaks = 368 npeaks was 368 zombified - calling shutdown handler could not attach as client (duplicate client name?) could not attach as client (duplicate client name?) MESSAGES: [ERROR]: failed to connect to JACK [ERROR]: failed to connect to JACK THIS HAPPENED: at stopping an 4 Stereo Channel Recording after 27mins, on a debian testing powerpc G3, using a hdsp and qjackctl with the following settings (taken from .jackdrc): /usr/bin/jackd -v -R -p64 -dalsa -r44100 -p512 -n2 -D -Chw:1 -Phw:1 -i18 -o18 I must say that i record onto an external firewire drive though, so this might be an issue here... The recordings seem ok, but i can only do a reconnect after restarting jack. Any suggestions are very welcome! regards, Peter