Hi all, In a tentative of giving more personality to the modular synth modules of the avw.lv2 set, I have been looking at clipping. I would like here to discuss here a few assumptions, the fruit of my research and get a few feedback/comments to decide what direction to take. - in some cases (or let say modules of a synth), clipping is implemented more to copie what an analogue system would do than a mandatory part of the algorithm... Let's take an example: 2 sin waves mixed together of amplitude -1/1 will just have an amplitude of -2/2 (as long as they are in phase)... A digital mixer without clipping would be able to cope with that, but an analogue one wouldn't... and that's why the analogue system would clip the signal......right? - What method of clipping is used will give a "personality" to the module: hard clipping, soft clipping, the method used for soft clipping, etc...right? - Hard clipping is something of the digital world - it doesn't exist in the analogue world... right? - Soft clipping will deform any waves of amplitude -1/1 even if it doesn't exceed the accepted threshold, because just before reaching the threshold the algorithm will take over and softly make the signal reach the maximum amplitude and keep it there until the original signal goes back under a set threshold.....right? - Is there a preferred stage for clipping? In the case of a filter, should we clip before filtering, after or both? Or are all these options valid and that's what will give an additional personality to the filter? Thanks in advance for any comments! Aurélien