11 Jun
2004
11 Jun
'04
5:03 a.m.
Hi Fernando,
first of all thenk you for your help!
I'm quite new to linux world, so I did not know until now that Envy24control
accepted parameters:-P.
I just runned Envy24control with -c parameter and the system correctly
recognize the three cards installed (IRQ3, IRQ5, IRQ7).
Now my problem is I can't find in Envy24control the option to set cards 1
and 2 (or hw:1 and hw:2) as slave: concerning hardware settings I can find
only a table which let me choose the clock (from 22050 to 96000, plus s/pdif
option) and "locked" and "reset" option can be activated after
choosing the
sample rate.
I can't fund any other option in Envy24control which seems to help to set
other boards as slaves.
I also noticed that running BruteFir is not possible if I set S/pdif in
sample rate options, BruteFir comes out with a "broken pipe error" at its
start and exits.
Thank you very much for your help, sorry for bother you!
Michele
P.S. You are doing an incredible job at PlanetCCarma! My best wishes!
It is not completely clear to me if you have run
envy24control on the
other two cards to set them to slave to wordclock. Envy24control can be
directed to use a particular card with the "-c x" parameter, where x is
0 for the first card, 1 for the second and so on and so forth.
-- Fernando
11 Jun
11 Jun
4:53 p.m.
New subject: [linux-audio-user] parameters needed for managing
I just runned Envy24control with -c parameter and the
system correctly
recognize the three cards installed (IRQ3, IRQ5, IRQ7).
Now my problem is I can't find in Envy24control the option to set cards 1
and 2 (or hw:1 and hw:2) as slave: concerning hardware settings I can find
only a table which let me choose the clock (from 22050 to 96000, plus s/pdif
option) and "locked" and "reset" option can be activated after
choosing the
sample rate.
The option should be in the "Hardware Settings" "Master Clock". There
should be a "word clock" option there. If your card has that (word clock
i/o) and there is no option there then you probably should post in the
alsa-devel list, it is probably a bug in recognizing exactly what your
card can do. I only have Midiman cards (the 1010 shows word clock as an
option altough I have not been able to get that to work - when needed I
sync through SPDIF).
I can't fund any other option in Envy24control
which seems to help to set
other boards as slaves.
I also noticed that running BruteFir is not possible if I set S/pdif in
sample rate options, BruteFir comes out with a "broken pipe error" at its
start and exits.
Do you have a source connected to the SPDIF input? Is it sending?
P.S. You are doing an incredible job at PlanetCCarma!
My best wishes!
Thanks!
-- Fernando
7562
days inactive
7562
days old
linux-audio-user@lists.linuxaudio.org
1 comments
2 participants
participants (2)
-
Fernando Pablo Lopez-Lezcano -
Michele Spinolo