I can't figure out how to record in any form. I have a hammerfall 96/52 card. I also have an intel card on the board but I removed the module (sudo modprobe -r snd_hda_intel) because I don't use it for anything on Linux. I am using the newest Ubuntu Studio and everything appears to work except when I record I get no sound signal. I can play sound in ardour, audacious, audacity, rezound, rtcmix using either native alsa or jack. Please help me to figure this out. Here is the info for the card: pmstudio@sphere:~/m/sounds$ cat /proc/asound/card0/rme9652 RME Digi9652 (Rev 1.5) (Card #1) Buffers: capture f6000000 playback f6200000 IRQ: 20 Registers bus: 0xfd000000 VM: 0xf88aa000 Control register: 4008 Latency: 1024 samples (2 periods of 4096 bytes) Hardware pointer (frames): 0 Passthru: no Clock mode: autosync Pref. sync source: ADAT1 ADAT1 Input source: ADAT1 optical IEC958 input: Coaxial IEC958 output: Coaxial only IEC958 quality: Consumer IEC958 emphasis: off IEC958 Dolby: off IEC958 sample rate: error flag set ADAT Sample rate: 44100Hz ADAT1: No Lock ADAT2: No Lock ADAT3: No Lock Timecode signal: no Punch Status: 1: off 2: off 3: off 4: off 5: off 6: off 7: off 8: off 9: off 10: off 11: off 12: off 13: off 14: off 15: off 16: off 17: off 18: off 19: off 20: off 21: off 22: off 23: off 24: off Thanks, Mike