I meant to reply to the list, so I am forwarding our conversation to the list, in case anyone else needs the info. 1) input gain/balance connects to bypass. 2) bypass connects to eq OR delay 3) eq connects to crossover 4a) crossover low connects to compressor 1 4b) crossover mid connects to compressor 2 4c) crossover high connects to compressor 3 5) each of the 3 compressors connects to its own stereo width/balance unit 6) all of the width/balance units connect to the boost unit 7) boost unit connects to the limiter 8) limiter connects to the master volume 9) master volume connects to output 10) delay (up at bypass above) connects to output ---------- Forwarded message ---------- From: Justin Smith <noisesmith(a)gmail.com> Date: Sat, Mar 28, 2009 at 6:06 PM Subject: Re: [LAU] JAMin and signal paths? To: Julien Claassen <julien(a)c-lab.de> On Sat, Mar 28, 2009 at 6:01 PM, Julien Claassen <julien(a)c-lab.de> wrote: A crossover is a unit that gives three outputs for every input (so this is two in six out), there is a low pass output, a mid range output, and a high pass output. The cutoff for the low pass is the same as the lower band of the mid range, and the cutoff for the high pass is the same as the upper band of the midrange, thus it cuts the audio into three distinct signals.