Hi It seems at least part of my problem with my edirol fa-66 firewire card is due to the fact that it shares interrupt with the graphic card :-( atte@vestbjerg:~$ lspci -v <snip> 00:02.0 VGA compatible controller: Intel Corporation Mobile GM965/GL960 Integrated Graphics Controll er (rev 03) (prog-if 00 [VGA controller]) Subsystem: Toshiba America Info Systems Unknown device ff50 Flags: bus master, fast devsel, latency 0, IRQ 17 Memory at f0000000 (64-bit, non-prefetchable) [size=1M] Memory at d0000000 (64-bit, prefetchable) [size=256M] I/O ports at 1800 [size=8] Capabilities: <access denied> <snip> 00:1a.0 USB Controller: Intel Corporation 82801H (ICH8 Family) USB UHCI Controller #4 (rev 03) (prog-if 00 [UHCI]) Subsystem: Toshiba America Info Systems Unknown device ff50 Flags: bus master, medium devsel, latency 0, IRQ 17 I/O ports at 1820 [size=32] <snip> 0a:01.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05) (prog-if 10 [OHCI]) Subsystem: Toshiba America Info Systems Unknown device ff50 Flags: bus master, medium devsel, latency 32, IRQ 17 Memory at f0400000 (32-bit, non-prefetchable) [size=2K] Capabilities: <access denied> <snip> I looked in the bios, but it seems interrupts can't be moved around (it's a toshiba laptop). Is there anyway to move the interrups by software? Anything else that could be done? Or should I simply admit I wasted my money and use the fa-66 as paper weight? -- Atte http://atte.dk http://modlys.dk