30 Apr
2013
30 Apr
'13
9:56 a.m.
Hi
Those who been interested could found a monophonic audio2midi LV2 plug
now in the guitarix git repository.
It is included in the gxtuner.lv2 plug now.
I have already a lot of fun driving calf monosynth with my guitar. :-D
http://sourceforge.net/p/guitarix/git/ci/master/tree/
greets
hermann
1 May
1 May
9:02 a.m.
On 04/30/2013 09:56 AM, hermann meyer wrote:
Hi
Those who been interested could found a monophonic audio2midi LV2 plug
now in the guitarix git repository.
It is included in the gxtuner.lv2 plug now.
I have already a lot of fun driving calf monosynth with my guitar. :-D
http://sourceforge.net/p/guitarix/git/ci/master/tree/
greets
hermann
Cool stuff Hermann! Hopefully I can still incorporate this in my
workshop for LAC2013 :)
Regards,
Jeremy
8:29 p.m.
Am 01.05.2013 09:02, schrieb Jeremy Jongepier:
On 04/30/2013 09:56 AM, hermann meyer wrote:
I wish you, and all who participate, a lot fun there, unfortunately
(fortunately :-) ), I've got the job were I'm talking about, that bounds
me for some time (I've got just a small time frame to get it done). So I
couldn't made it to the LAC2013.
greets
hermann
Hi
Those who been interested could found a monophonic audio2midi LV2 plug
now in the guitarix git repository.
It is included in the gxtuner.lv2 plug now.
I have already a lot of fun driving calf monosynth with my guitar. :-D
http://sourceforge.net/p/guitarix/git/ci/master/tree/
greets
hermann
Cool stuff Hermann! Hopefully I can still incorporate this in my
workshop for LAC2013 :)
Regards,
Jeremy
10:17 p.m.
On 04/30/2013 09:56 AM, hermann meyer wrote:
Hi
Those who been interested could found a monophonic audio2midi LV2 plug
now in the guitarix git repository.
It is included in the gxtuner.lv2 plug now.
I have already a lot of fun driving calf monosynth with my guitar. :-D
http://sourceforge.net/p/guitarix/git/ci/master/tree/
greets
hermann
Played around with it too but it didn't help that the guitar I was using
is badly intonated ;) So I got a lot of wrong notes. Would it be
possible to add something like an autotuner in the vain of zita-at1
where you can set the notes you want gxtuner to output?
Jeremy
2 May
2 May
5:36 a.m.
Am 01.05.2013 22:17, schrieb Jeremy Jongepier:
On 04/30/2013 09:56 AM, hermann meyer wrote:
That sounds like a good idea to me, providing a list with "allowed
notes" and a range from were to snap in. I will work that out. :-)
I've get best results when the threshold level is a way higher(-40db)
then the default (-50db), and the note on level is just a bit higher
then the threshold (threshold is now as well in db)
greets
hermann
Hi
Those who been interested could found a monophonic audio2midi LV2 plug
now in the guitarix git repository.
It is included in the gxtuner.lv2 plug now.
I have already a lot of fun driving calf monosynth with my guitar. :-D
http://sourceforge.net/p/guitarix/git/ci/master/tree/
greets
hermann
Played around with it too but it didn't help that the guitar I was
using is badly intonated ;) So I got a lot of wrong notes. Would it be
possible to add something like an autotuner in the vain of zita-at1
where you can set the notes you want gxtuner to output?
Jeremy
9:57 a.m.
On 05/02/2013 05:36 AM, hermann meyer wrote:
That sounds like a good idea to me, providing a list with "allowed
notes" and a range from were to snap in. I will work that out. :-)
That would be cool! Of course you can also put Zita-AT1 itself in front,
or the zita-retuner LV2 plugin.
I've get best results when the threshold level is
a way higher(-40db)
then the default (-50db), and the note on level is just a bit higher
then the threshold (threshold is now as well in db)
I'm going to try that too. Now with a properly intonated guitar ;)
Jeremy
greets
hermann
10:11 a.m.
Am 02.05.2013 09:57, schrieb Jeremy Jongepier:
Try as well the single note switch, that will clip Notes, which come up
for short, early down.
On 05/02/2013 05:36 AM, hermann meyer wrote:
Yes, but that will introduce some overhead which we could avoid by a
simple list to select the "wanted notes" from. I just need to figure out
now how I could use the lv2:CVPort, so that we could commit the list
from UI to engine.
I guess you have note that the hole LV2 gxtuner including the midi
output need less then 2% of your CPU ?
That sounds like a good idea to me, providing a list with "allowed
notes" and a range from were to snap in. I will work that out. :-)
That would be cool! Of course you can also put Zita-AT1 itself in
front, or the zita-retuner LV2 plugin.
I've get
best results when the threshold level is a way higher(-40db)
then the default (-50db), and the note on level is just a bit higher
then the threshold (threshold is now as well in db)
I'm going to try that too. Now with a properly intonated guitar ;)
Jeremy
greets
hermann
10:25 a.m.
On 05/02/2013 10:10 AM, hermann meyer wrote:
I guess you have note that the hole LV2 gxtuner
including the midi
output need less then 2% of your CPU ?
Haven't noticed that yet. I got absorbed by playing guitar and listening
to Will J Godfrey's Silver Bell coming out of Yoshimi ;)
Try as well the single note switch, that will clip
Notes, which come up
for short, early down.
I already enabled that switch as I've experienced that the MIDI output
is more accurate with the single note option enabled.
Jeremy
8:38 p.m.
Am 02.05.2013 10:25, schrieb Jeremy Jongepier:
Haven't noticed that yet. I got absorbed by
playing guitar and
listening to Will J Godfrey's Silver Bell coming out of Yoshimi ;)
I've add a low/high cut filter before the tuner now, to remove all
frequency’s which are out of the tuner range (30<->999hz) before
analyze. As well a additional highpassfilter (-3db) at 100hz to reduce
the influence of the lower freqs in the overall analysis.
That makes the midi output a way cleaner.
greets
hermann
Try as well the single note switch, that will
clip Notes, which come up
for short, early down.
I already enabled that switch as I've experienced that the MIDI output
is more accurate with the single note option enabled.
Jeremy
8:43 p.m.
On 05/02/2013 08:38 PM, hermann meyer wrote:
I've add a low/high cut filter before the tuner
now, to remove all
frequency’s which are out of the tuner range (30<->999hz) before
analyze. As well a additional highpassfilter (-3db) at 100hz to reduce
the influence of the lower freqs in the overall analysis.
That makes the midi output a way cleaner.
greets
hermann
Cool, cool. I just picked up the guitar I'm going to use at LAC2013 from
my guitar repair guy so it's well intonated again. I'm currently
rebuilding the whole LV2 stack and if that's done I'll rebuild guitarix
from git too.
Jeremy
8:54 p.m.
On Thu, 2013-05-02 at 20:42 +0200, Jeremy Jongepier wrote:
Cool, cool. I just picked up the guitar I'm going
to use at LAC2013 from
my guitar repair guy so it's well intonated again.
That's what you think NOW... just wait until the airline is finished
with that guitar!
(hopefully hyperbolizing)
Bill Gribble
9:03 p.m.
On 05/02/2013 08:54 PM, Bill Gribble wrote:
That's what you think NOW... just wait until the
airline is finished
with that guitar!
(hopefully hyperbolizing)
Bill Gribble
Hi Bill,
It's a shortscale so hopefully I can take it with me in the cabin. I'm
flying with Lufthansa and a few years ago I could take my (acoustic)
guitar with me in the cabin too on a Lufthansa flight. Otherwise,
bummer, I'm not taking any of my precious vintage guitars with me but a
$150 worth piece of plastic.
Jeremy
9:25 p.m.
Am 02.05.2013 20:42, schrieb Jeremy Jongepier:
Cool, cool. I just picked up the guitar I'm going to use at LAC2013
from my guitar repair guy so it's well intonated again. I'm currently
rebuilding the whole LV2 stack and if that's done I'll rebuild
guitarix from git too.
Jeremy
Looks like I need to build the LV2 stack as well on my own, to be able
to use the lv2:CVPort extension. The freeze in debian seems to me like a
never ending story now, and debian/sid slips slowly into a outdated
state. I also didn't help to enable the experimental repo, (last jalv
version in experimental is 1.2.0).:-(
8:45 p.m.
On Thu, 02 May 2013 10:25:16 +0200
Jeremy Jongepier <jeremy(a)autostatic.com> wrote:
On 05/02/2013 10:10 AM, hermann meyer wrote:
Well now, that's really nice to know :) :) :)
--
Will J Godfrey
http://www.musically.me.uk
Say you have a poem and I have a tune.
Exchange them and we can both have a poem, a tune, and a song.
I guess you have note that the hole LV2 gxtuner
including the midi
output need less then 2% of your CPU ?
Haven't noticed that yet. I got absorbed by playing guitar and listening
to Will J Godfrey's Silver Bell coming out of Yoshimi ;)
8:51 p.m.
On 05/02/2013 08:45 PM, Folderol wrote:
Well now, that's really nice to know:) :) :)
It's basically my default instrument. I should actually make an alias
yoshimi='yoshimi -L
/usr/share/yoshimi/banks/Will_J_Godfrey_Collection/0005-Silver\ Bell.xiz' ;)
In other words, I really like that instrument.
Jeremy
18 May
18 May
8:39 p.m.
Am 02.05.2013 10:10, schrieb hermann meyer:
Done. I have added a note-board to select the allowed
notes from. It's
in git now.
Currently without a range selection to group notes, I need to think
about how to implement it best.
greets
hermann
That would be cool! Of course you can also put Zita-AT1 itself in
front, or the zita-retuner LV2 plugin.
Yes, but that will introduce some overhead which we could avoid by a
simple list to select the "wanted notes" from. I just need to figure
out now how I could use the lv2:CVPort, so that we could commit the
list from UI to engine.
9:13 p.m.
On 05/18/2013 08:39 PM, hermann meyer wrote:
Am 02.05.2013 10:10, schrieb hermann meyer:
Done. I have added a note-board to select the allowed
notes from. It's
in git now.
Currently without a range selection to group notes, I need to think
about how to implement it best.
greets
hermann
Awesome, time to build guitarix from git again :)
Jeremy
That would be cool! Of course you can also put Zita-AT1 itself in
front, or the zita-retuner LV2 plugin.
Yes, but that will introduce some overhead which we could avoid by a
simple list to select the "wanted notes" from. I just need to figure
out now how I could use the lv2:CVPort, so that we could commit the
list from UI to engine.
4240
days inactive
4258
days old
linux-audio-user@lists.linuxaudio.org
16 comments
4 participants
participants (4)
-
Bill Gribble -
Folderol -
hermann meyer -
Jeremy Jongepier